I replaced some wiring on the input line where it connected to the tap. I would appreciate if someone in the know could look at these signal levels to check that they are in range and some feel for whether they are good, bad, or indifferent, thanks:
Model: Cisco DPQ3212 - Vendor: Cisco
Hardware Revision: 1.0
MAC Address: xx:xx:xx:xx:xx:xx
Bootloader Revision: 2.3.0_R1
Current Software Revision: d3200-P10-5-c1000r5593-150324a-COX
Firmware Name: d3200-P10-5-c1000r5593-150324a-COX.bin
Firmware Build Time: Apr 1 10:01:32 2015
Cable Modem Status: Operational
--------------------------------------------------------------------------------
Cable Modem State
DOCSIS Downstream Scanning: Completed
DOCSIS Ranging: Completed
DOCSIS DHCP: Completed
DOCSIS TFTP: Completed
DOCSIS Data Reg Complete: Completed
DOCSIS Privacy: Enabled
--------------------------------------------------------------------------------
Downstream Channels
Power Level: Signal to Noise Ratio:
Channel 1: -6.9 dBmV 38.9 dB
Channel 2: -7.7 dBmV 38.3 dB
Channel 3: -8.3 dBmV 37.8 dB
Channel 4: -8.8 dBmV 37.6 dB
Channel 5: -12.1 dBmV 35.8 dB
Channel 6: -12.4 dBmV 35.3 dB
Channel 7: -13.1 dBmV 34.3 dB
Channel 8: -13.5 dBmV 34.3 dB
--------------------------------------------------------------------------------
Upstream Channels
Power Level:
Channel 1: 45.5 dBmV
Channel 2: 44.7 dBmV
Channel 3: 45.2 dBmV
Channel 4: 45.2 dBmV
↧